|
You must add a Dialup entry on your Scanner for each of the different
Internet Service areas you travel through.
For the
8800, set your dial up connections as follows:
1)
Click: Start
-> Settings.
2)
Click Connections
tab at bottom of screen.
3)
Click Connections
icon towards top of screen.
4a)
Click Add a new modem
connection" if one doesn't exist, or
4b)
Click Manage existing
connections to edit an existing one.
5a) If only
one entry exists, click the Edit
button
5b) If more
than one entry exists, highlight (select) the one you want to edit
before clicking the Edit
button
6)
Enter a name for the connection, keep it simple example: Joes
Dialup
7)
For Modem: select Hayes
Compatible on COM1:
8)
Click the Next
button
9)
For the phone number, enter it as though you were direct
dialing it:
a.
Include Area Code if 10-digit dialing for
local calls is required (its
required in Texas).
Example:
AAANNNNNNN (where A
is area code, and N is
7-digit ISP dial up phone number)
b.
Include any outside line access codes a PBX may require
a 9, (thats a Nine
Comma).
Not usually
required for residential dial up, only if youre dialing within an
Office/PBX environment.
10)
Click the Next
button
11)
Enter the User Name
for the Dial up (ISP) connection (Not the FTP User Name!)
12)
Enter the Password
for the Dial up (ISP) connection (Not the FTP Password!)
13)
Leave the Domain
field Blank/Empty.
14)
Click the Advanced
button
a.
On the General
tab:
i.
Baud Rate = 57,600 (If you have a noisy phone system,
try 38,400)
ii.
Checkmark is checked for wait
for dial tone
iii.
Checkmark is checked for Cancel
if not connected in
iv.
Set cancel timeout to 120
seconds (the default)
b.
On the Port Settings
tab:
i.
Data bits = 8
ii.
Parity = None
iii.
Stop bits = 1
iv.
Flow Control = Hardware
v.
Checkmark is cleared for Use
Terminal before connecting
vi.
Checkmark is cleared for Use
Terminal after connecting
vii.
Checkmark is cleared for Use
dialing commands manually
c.
On the TCP/IP
tab:
i.
Use server-assigned IP
address is selected.
(Use
specific IP address is NOT selected)
ii.
Checkmark is cleared for Use
slip
iii.
Checkmark is checked for Use
software compression
iv.
Checkmark is checked for Use
IP header compression
d.
On the Servers
tab:
i.
Use server-assigned
addresses is selected.
(Use
specific server address is NOT selected)
ii.
Everything else on this screen is left blank/empty
15)
Click the OK
button on the top right corner of this screen
(This takes
you back to the User name and Password screen)
16)
Click the Finish
button
(This takes
you back to the My ISP
screen with your dialup entry listed)
17)
Click the OK
button on the top right corner of this screen.
(This takes
you back to the Connections
main screen)
18)
Click the OK
button on the top right corner of this screen.
(This takes
you back to the Settings
main screen)
19)
Click the X
button on the top right corner of this screen.
(This takes
you back to the Today
screen on your Scanner)
>> Youre
done! <<
|
